Printed postal boxes directly from the manufacturer

Sturdy printed cardboard boxes with double sidewall for 3D mailings and for mailing by post. The postal boxes are closed on the underside of the front. The closure can be opened at a finger hole and the lid flap can then be opened in a visually appealing way.

Folding boxes in white or printed

The folding boxes, also known as mail boxes, can be printed on all 6 outer surfaces and 4 inner surfaces. Particularly attractive for the design is also the printing of the bottom surface inside. This allows additional information to be printed that only appears after the contents have been removed, such as "Thank you for your order" or information about other products.

In order to additionally increase the attention for your product as well as the conveyed value, we also have the possibility to finish the foldable postal boxes with different printing processes such as drip offset printing, screen printing or foil stamping. For example, glossy, metallic or haptic effects can be realised. In addition, the printed image can be pimped by embossing, for example, the logo on the folding container.

The mailbox and storage box can also be equipped with a foil window or a punched-out area in the lid, for example for the address field.

Assembly of the postal boxes

The postal boxes are delivered flat to save space and can then be set up as follows: First, the 4 small corner flaps are folded at a 90° angle. Then the front and rear grooved edges of the bottom surface are folded upwards so that the two side flaps above them can be folded inwards. Now the large front bottom flap is crimped over it, thus fixing the bottom container of the folding box.

Now the box can be filled. To close it, fold the two side flaps on the lid inwards. In such a way that when closing the lid flap, these thread between the product and the side flaps. The folding box can now be closed with the small cardboard locking tab on the lid.

Subdivisions for better fixation

We can also make cardboard dividers and inserts to fix your product in the mailbox. To do this, we need a sketch of the product or, even better, an original sample so that we can adapt the insert exactly to it. So that you can test the suitability of the shipping packaging with insert, we will create a plotted box sample from the original cardboard.

The right material

Depending on the weight and intended use of the box, we recommend other cardboard materials. Therefore, please also state the weight of the contents with your enquiry. For additional protection for mailing, the boxes can also be covered with matt film, glossy film or soft-touch film.

Possible uses of the Tuck-in boxes

Plug-in tab boxes are often used for: Software, medicines such as tablets, pills, tubes, jars, vials, ampoules Cosmetics such as perfume, mailings, promotional gifts or as postal or shipping packaging

Request a free offer

Dimensions

10 x 5 x 20 cm

Please enter your desired measurement here. If you are not sure, just enter a rough measurement.

Printing

Which printing would you like?

Product selection

What type of box do you want?